Over time the Oil Plus 2C treated surface may show some wear. Indications for wear are a visible walking zone, a surface that is more stain-sensitive and remains wet for a longer time after cleaning. If the surface shows much wear and tear or it needs a colour repair, you need to re-apply Oil Plus 2C in the colour that the wood was originally treated with.
Note: If the wooden object is too much damaged or neglected, you will first need to sand the surface and end with the same screening grit as you initially finished your wooden object with.Instructions
- Step 1: Clean the surface with Deep Cleaner
- Step 2: Rinse well with clean water
- Step 3: Mix the two components (A and B) together
- Step 4: Apply Oil Plus 2C
- Step 5: Let it absorb for a few minutes and wipe away all excess oil
- Step 6: Let it dry for 12 - 24 hours
Step 1: Clean the surface with Deep Cleaner
- Dampen the surface with just water and using a mop or sponge.
- Dilute the Deep Cleaner with water (5% Deep Cleaner to 95% water).
- Scrub the area with the dilution and a nylon scrubbing brush in the lengthwise direction of the wood. Do this until the surface is clean and spot free.
- Note: for stubborn stains, repeat the treatment or use one of our stain removers ( Grease Remover, Limespot Remover or Tannin Remover).
Step 2: Rinse well with clean water
- Remove the dissolved dirt with a mop and clean water until all the foam has disappeared and the surface looks clean again.
- Allow the surface to dry well (± 30 minutes at a temperature of 20°C and in a well-ventilated room).
Step 3: Mix the two components (A and B) together
- Stirr the A component until a homogenous mixture is obtained. Carefully mix the two components (1 to 2 minutes) with a ratio of appr. 3 units A to 1 unit B.
- Attention, the mixture of A and B can only be used during 4 - 6 hours. So be careful and only mix the amount you'll need in that timeframe.
Step 4: Apply Oil Plus 2C
- Spread out a small quantity of Oil Plus 2C using a beige or red Scrubby pad or hand sander with a small beige 5.9 inch Pad (you can also use the Mouse Pad for smaller objects and corners).
Step 5: Let it absorb for a few minutes and wipe away all excess oil
- Let absorb during a few minutes. Wipe away all excess oil with a cloth or a hand sander with a small white 5.9 inch pad. Finish off with a cloth within max. 30 minutes. The surface should feel non-sticky!
Step 6: Let it dry for 12 - 24 hours
- Let the surface dry for 12 to 24 hours and wait at least 5 days to clean with water and Universal Soap, Surface Care, All Natural Wood Cleaner or All Natural Wood Cleaner Spray.
Cloths and other tools, saturated with oil, may spontaneously combust. After usage, they need to be soaked in water before disposal.
- When using several containers at one site, it is required to mix them for an even result.
- After application the surface may appear a bit glossy. This will disappear after cleaning 2 - 3 times with Universal Soap, Surface Care, All Natural Wood Cleaner or All Natural Wood Cleaner Spray.
- Only use our maintenance and cleaning products.