Oil Plus 2C is a VOC-free hardwax oil of the newest generation which colours and protects your wood in one single layer. It's perfectly suitable for high traffic zones and can be applied to all interior wood surfaces (furniture, countertops, tabletops, stairs, walls, floors, etc.), almost all wood types and wood species (solid wood, veneer, MDF, etc.). The combination of the oil (A) and the Accelerator (B) guarantees a quick curing for optimal protection.
Instructions to apply Oil Plus 2C on floors
- Step 1: Sand the surface
- Step 2: Vacuum thoroughly and clean with Cleaner
- Step 3: Mix the two components (A and B) together
- Step 4: Apply Oil Plus 2C
- Step 5: Let it absorb for a few minutes and wipe away all excess oil
- Step 6: Pass again with a new white Rubio Monocoat Pad
- Step 7: Let the surface dry for 12 - 24 hours
Step 1: Sand the surface
- Sand the surface scratch-free. Finish with screening net 100. (When renovating, you must first remove all the residues from previous treatments completely.)
Step 2: Vacuum thoroughly and clean with Cleaner
- Vacuum thoroughly, eliminate remains of dust with Cleaner and wait until the surface is completely dry.
Step 3: Mix the two components (A and B) together
- Stir the A component until a homogenous mixture is obtained. Carefully mix the two components (1 to 2 minutes) with a ratio of appr. 3 units A to 1 unit B.
- Attention, the mixture of A and B can only be used during 4 - 6 hours. So be careful and only mix the amount you'll need in that timeframe.
Step 4: Apply Oil Plus 2C
- Work in zones of 5 - 10 m². Start each zone by treating the borders with a beige or red Scrubby pad. Then apply a small quantity of Oil Plus 2C every other 0,5 meters using a brush. Spread out plank-wise using a polishing machine with a beige or red 16 inch pad.
*Spatula method: Spread out Oil Plus 2C with a stainless spatula in zones which can be finished in maximum 30 minutes (including steps 5 and 6).
Step 5: Let it absorb for a few minutes and wipe away all excess oil
- Thoroughly remove all excess oil with a cloth or a polishing machine with a white 16 inch pad. The surface should feel non-sticky!
Step 6: Pass again with a new white Pad
- After having finished all the zones, pass again with a new white pad. Now the surface should feel non-sticky.
Step 7: Let the surface dry for 12 - 24 hours
- Let the surface dry for 12 to 24 hours and wait at least 5 days to clean with water and Universal Soap or All Natural Wood Cleaner.
Cloths and other tools which are saturated with oil may spontaneously combust. After usage, they need to be soaked in water before disposal.
- To determine the correct colour, always do a small test first with one of our 20 ml sample bottles on identical sanded and prepared wood.
- When using several containers at one site, it is required to mix them for an even result.
- Only use our maintenance and cleaning products.
- After application the surface may appear a bit glossy. This will disappear after cleaning 2 - 3 times with Universal Soap or All Natural Wood Cleaner.
- For greasy wood species (e.g. Teak, Iroko, Kambala, Wengé, Eucalyptus, Merbau, Afzelia, Afrormosia, etc.), use Deep Cleaner instead of Cleaner.