How can we remove overlapping of DuroGrit?

Small errors can be touched-up on the wet surface up to 15 minutes after application, depending on the weather conditions. Apply a bit of extra DuroGrit with a brush. Put some pressure with your brush to dissolve and mix the old product with the new one. Go over it several times and smooth out.

If you are too late and the surface is already dry, you can remove the overlap by lightly manually sanding the product away in the direction of the grain and applying some new product. It is best to do such a correction before the product is completely cured (e.g. during the installation and not a few days later).