Oil Plus 2C is a VOC-free hardwax oil of the newest generation which colours and protects your wood in one single layer. It's perfectly suitable for high traffic zones and can be applied to all interior wood surfaces (furniture, countertops, tabletops, stairs, walls, floors, etc.), almost all wood types and wood species (solid wood, veneer, MDF, etc.). The combination of the oil (A) and the Accelerator (B) guarantees a quick curing for optimal protection.
Instructions to apply Oil Plus 2C on interior furniture, stairs & countertops
- Step 1: Sand the surface
- Step 2: Vacuum thoroughly and clean with Cleaner
- Step 3: Mix the two components (A and B) together
- Step 4: Apply Oil Plus 2C
- Step 5: Let it absorb for a few minutes and wipe away all excess oil
- Step 6: Let it dry for 12-24 hours
Step 1: Sand the surface
- Sand the surface scratch-free. Finish with screening net 100 to 150. (When renovating, you must first remove all the residues from previous treatments completely.)
Step 2: Vacuum thoroughly and clean with Cleaner
- Vacuum thoroughly, eliminate remains of dust with Cleaner and wait until the surface is completely dry.
Step 3: Mix the two components (A and B) together
- Stir the A component until a homogenous mixture is obtained. Carefully mix the two components (1 to 2 minutes) with a ratio of appr. 3 units A to 1 unit B.
- Attention, the mixture of A and B can only be used during 4-6 hours. So be careful and only mix the amount you'll need in that timeframe.
Step 4: Apply Oil Plus 2C
- Spread out a small quantity of Oil Plus 2C using a beige or red Scrubby pad or hand sander with a small beige 5.9 inch Pad (you can also use the Mouse Pad for smaller objects and corners).
- Spatula method: spread the Oil Plus 2C out with a stainless spatula in zones which can be finished within maximum 30 minutes (next step included!)
- For ceilings and walls you can use our Brush and beige Scrubby pad to spread out the oil
Step 5: Let it absorb for a few minutes and wipe away all excess oil
- Let absorb during a few minutes. Wipe away all excess oil with a cloth or a hand sander with a small white 5.9 inch pad. Finish off with a cloth within max. 30 minutes. The surface should feel non-sticky!
Step 6: Let it dry for 12-24 hours
- Let dry the surface for 12 to 24 hours and wait at least 5 days to clean with water and Surface Care or All Natural Wood Cleaner Spray.
Cloths and other tools which are saturated with oil may spontaneously combust. After usage, they need to be soaked in water before disposal.
- To determine the correct colour, always do a small test first with one of our 20 ml sample bottles on identical sanded and prepared wood.
- When using several containers at one site, it is required to mix them for an even result.
- After application the surface may appear a bit glossy. This will disappear after cleaning 2-3 times with Surface Care or All Natural Wood Cleaner Spray.
- Only use our maintenance and cleaning products.
- For greasy wood species ( e.g. Teak, Iroko, Kambala, Wengé, Eucalyptus, Merbau, Afzelia, Afrormosia, etc.), use Deep Cleaner instead of Cleaner.
- Tannin Primer can be used before applying the Oil Plus 2C for horizontal surfaces often subjected to liquids such as worktops or bathroom furniture.
*Spatula method: